Rhin-o-tuff OD4012 User Manual

Instruction Bookfor the OD4012,OD4000 and OD4800

8uuuuuInstall the die by sliding it into the opening of the machine located onthe left hand side of the machine. Make sure the punch pin retainerslide

9Removing Punch Pins? Turn machine power off and remove die assembly from the machine. On the opposite side of the die assembly from the die handle,

10Setting the paper stop/guide:uuOD4012, OD4000 and OD4800 -Locate the paper stop on the front cover of the machine. Loosen theknob counterclockwise,

11Paper Jam:u The OD4012 and OD4000 punches use a circuit board for controllingthe punch cycle, this circuit board also has the ability to automatical

12u OD4000 Manual ReverseLocate the silver plugon the rear of the left side panel of themachine. Remove the silver plug by prying itout gently with a

13Machine does not cycleSymptom Possible CauseActionTroubleshootingDie does not go into machine1) Machine is off2) Machine is not plugged in3) Foot-pe

Be sure to fill out and return your ProductWarranty Registration Card or Register onlineat:www.Rhin-O-Tuff.com/warranty_registration.aspPart Number 00

OD4012, OD4000 and OD4800Setup & Operator ManualIssue 3 June 09Performance Design LLC.These punches have been designed to punch most any job that

OD4012 Contents S/N:_______________Punch (1) ___Instruction Book (1)___Oil (1) ___Brush (1)___Foot Pedal (1) ___Power Cord (1)___Reversing Tool (1)Ins

Table of ContentsTopic: Page Number:3Safety Alert SymbolsSafe operating guidelinesProper machine placementAttach OD4800 HandleProviding electric power

Safety Alert Symbolsu The OD4012 and OD4000 need to be plugged into a wall outlet thatprovides a 15-amp, 120 volt service (16-amp, 220 volt for Europe

5Placing your machine in the proper location:u Before lifting machine, turn power off andremove the power cord from the wall outlet.The machine is ver

6Attach Handle to OD4800:u The OD4800 manual punch is shipped with the handle removed fromthe punch. You will need two 3/8” wrenches (not supplied) to

7Providing power to the machine:u Power cord shall be certified for the countrywhere the machine will be installed. Plug oneend of the power cord into